Concrete resurfacing

Posted on Thursday, November 27th, 2014 at 12:55 am

A concrete patio or driveway that has broken away can look tatty and untidy so the best thing to do is to get a concrete resurfacer. After all you don’t want the neighbours talking about your below par sidewalk!

Resurfacing concrete is not as difficult a job as most people would think, and to be honest it is actually pretty easy. All you have to do is follow some simple steps when resurfacing concrete and your driveway will look as good as new within eight to ten hours. What are the rules of concrete resurfacing you ask?

Well there are seven rules to concrete resurfacing in all and they can all be found below. 

Prepare the surface
Concrete resurfacing shouldn’t be a repair job as such, but more of a cosmetic surgery application. Basically what this means is if the concrete surface you are trying to resurface is not structurally sound then you shouldn’t try and resurface it because it will only paper over the cracks for a limited amount of time and then the problem will arise again. If you want your concrete surface to look as good as new you need to deal with the surfacing problems first, if there are any, and then resurface the concrete after. For decorative concrete resurfacing in Melbourne, just click the hyperlink provided for details.

Clean the surface
Cleaning the surface is imperative when you are resurfacing concrete because you don’t want any lumps or spots where the concrete has not set properly because it was dirty. This means cleaning stains, debris and pretty much anything that could stop the concrete resurfacer from doing its job. For best epoxy flooring, click the link provided for more information and for all inquiries.

Mix it up
The next step is to mix up the resurfacer, and to do this you are going to need a lot of water. For a forty pound bag of concrete resurfacer you will need around three and a half quarts of water to make the mix properly. Pour the water into a container and then gradually start adding the concrete resurfacer, mixing until it has reached a smooth, pourable consistency of syrup. Add more water or concrete resurfacer if necessary. If it is a warm day then use cold water to mix the resurfacer and warm water if it is a cold day.

Wet down the surface
Making sure the surface is wet before adding the concrete resurfacer is very important because it means that the surface does not draw moisture out of the resurfacer, which could ruin the mix and make it not set.

Apply
Apply small amounts of the resurfacer onto the surface and then spread it out evenly. Repeat this until all the surface has been covered evenly in concrete resurfacer.

Scuff the surface
If the surface you are resurfacing is a patio or a driveway then concrete resurfacer can make it very slippery so you will want to scuff it up by making long strokes across the mix with a long handed broom to add more traction.

Let it cure
Concrete resurfacer needs to cure which takes around a month to do properly. However do not fear you can walk on it after about eight hours.

Both comments and pings are currently closed.

Comments are closed.